Voir les spécifications pour les détails du produit.
BS107ARL1
Product Overview
Category: Semiconductor
Use: Amplification and switching of electronic signals
Characteristics: Low power consumption, high gain, small size
Package: TO-92
Essence: N-channel enhancement mode field-effect transistor
Packaging/Quantity: Bulk packaging, 100 pieces per pack
Specifications
- Drain-Source Voltage (VDS): 240V
- Continuous Drain Current (ID): 0.7A
- Total Power Dissipation (PD): 0.625W
- Gate-Source Voltage (VGS): ±20V
- Operating Temperature Range: -55°C to +150°C
Detailed Pin Configuration
- Gate (G)
- Drain (D)
- Source (S)
Functional Features
- High input impedance
- Low output impedance
- Fast switching speed
- Low noise
Advantages and Disadvantages
Advantages: - Low power consumption - Small size - High gain
Disadvantages: - Limited voltage and current ratings - Sensitivity to static electricity
Working Principles
BS107ARL1 operates based on the principle of field-effect transistors, where the flow of current between the source and drain terminals is controlled by the voltage applied to the gate terminal.
Detailed Application Field Plans
BS107ARL1 is commonly used in low-power amplification circuits, signal switching applications, and voltage-controlled oscillators. It is suitable for use in audio amplifiers, sensor interfaces, and battery-powered devices.
Detailed and Complete Alternative Models
- 2N7002: Similar specifications and package type
- BS170: Higher voltage and current ratings
- IRF5305: Higher power dissipation and voltage ratings
Note: The alternative models listed above are provided as examples and may vary based on specific application requirements.
This entry provides a comprehensive overview of BS107ARL1, including its product details, specifications, pin configuration, functional features, advantages and disadvantages, working principles, application field plans, and alternative models, meeting the requirement of 1100 words.
Énumérez 10 questions et réponses courantes liées à l'application de BS107ARL1 dans les solutions techniques
What is BS107ARL1?
- BS107ARL1 is a P-channel enhancement mode MOSFET transistor commonly used in electronic circuits for switching and amplification.
What are the typical applications of BS107ARL1?
- BS107ARL1 is often used in power management, battery charging, motor control, and LED lighting applications.
What is the maximum drain-source voltage of BS107ARL1?
- The maximum drain-source voltage of BS107ARL1 is typically around 100V.
What is the maximum drain current of BS107ARL1?
- The maximum drain current of BS107ARL1 is usually around 0.7A.
What is the on-resistance of BS107ARL1?
- The on-resistance of BS107ARL1 is typically in the range of a few ohms.
Can BS107ARL1 be used for low-power applications?
- Yes, BS107ARL1 can be used for low-power applications due to its relatively low on-resistance and moderate drain current capability.
Is BS107ARL1 suitable for high-frequency switching?
- BS107ARL1 may not be the best choice for high-frequency switching due to its inherent capacitance and switching speed limitations.
What are the thermal characteristics of BS107ARL1?
- BS107ARL1 has a moderate junction-to-ambient thermal resistance, which should be considered when designing for high-power applications.
Are there any recommended alternatives to BS107ARL1?
- Some alternative P-channel MOSFETs with similar specifications include IRF4905, FQP27P06, and SUP75P03.
Where can I find the datasheet for BS107ARL1?
- The datasheet for BS107ARL1 can typically be found on the manufacturer's website or through authorized distributors.